10025 Hardware HARDWARE: DPE LCA's not configured at startup All The Xilinx LCA's on the DPE were not loaded on startup. They are normally loaded using a file stored in the code bank. To determine if this file is corrupted or missing, use the "fw dir" command. Look for the entries labelled "DPE LCA". If there, look under the "Chksum" column for either "PASS" or "FAIL". If it says FAIL, or if no DPE entry is there, the code bank must be programmed again. If the DPE entry PASS'es, the incorrect firmware file may have been loaded, or the DPE LCA's may be faulty. Record error message and contact Creo Service Firmware has been corrupted. Incorrect or incomplete firmware installed. Faulty DPE LCA's ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:32:30 2008 PST